In this story
Where: Media → Photo settings (Watermark section)
Open this page: admin.<your-site>/settings/media#watermark (replace <your-site> with your site address)
Before you start
Add and publish your logo first. If you have not, you see "Add and publish your logo first, then it can be stamped on images." with Open Branding.
Steps
- Open Media, then Photo settings. The page is titled Media settings. Find Watermark.
- Turn on Stamp my logo on images.
- Under Position, choose Top left, Top right, Centre, Bottom left or Bottom right.
- Set Opacity and Logo size.
- Under Put it on these sizes, choose Whole image or the crop shapes.
- Tap Save.
- To stamp older pictures, tap Re-apply to outdated images.
Good to know
- It applies to new uploads. Older pictures change only when you re-apply.
- The switch stays off until a logo is published.
Common problems
- The switch is off. Publish a logo in Branding first.
Questions
Frequently asked questions
Will the original be stamped?
No.
Can I choose where the logo goes?
Yes. Pick one of five positions.